自锁模激光器腔内倾斜增益介质的实验特性研究
DOI:
作者:
作者单位:

杭州电子科技大学

作者简介:

通讯作者:

中图分类号:

TN248

基金项目:

国家自然科学基金(62105179)、浙江省基础研究与发展计划(2023C03014)、浙江省自然科学基金联合基金(LZY21F050001)和浙江省重点研究与发展项目(2022C03037)资助项目


Experimental characteristics of tilted gain medium in a self mode-locked laser cavity
Author:
Affiliation:

hangzhou dianzi university

Fund Project:

Supported by the National Natural Science Foundation of China (62105179), Zhejiang Basic Research and Development Plan (2023C03014), Zhejiang Natural Science Foundation Joint Fund (LZY21F050001), and Zhejiang Key Research and Development Project (2022C03037)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过旋转线性激光腔内增益介质,研究了Nd:YVO4多纵模激光器腔内标准具倾斜角对输出纵模分布的影响。建立理论模型,分析了Nd:YVO4激光器中标准具效应对输出多纵模特性的影响,并进行了相应的实验研究。在实验中,通过旋转晶体角度,探究纵模分组和光谱漂移现象。实验结果表明,当激光晶体角度从0?开始增加时,会产生标准具透射峰线宽变宽和纵模波长红移两种现象。实验结果与理论模型符合较好。最后,当泵浦功率为2768 mW,激光晶体倾斜角为0.45?时成功抑制了标准具效应,获得了斜率效率和光学转换效率为15.66%和13.9%,输出功率为385 mW,光束质量为1.71的锁模激光。此时通过增加泵浦功率,发现空间烧孔效应也会产生与标准具效应相类似的效果。实验结果还表明增加泵浦功率会使空间烧孔现象加剧。

    Abstract:

    The influence of the tilt angle of the intracavity standard on the output longitudinal mode distribution of Nd:YVO4 multi longitudinal mode laser was studied by rotating the linear laser intracavity gain medium. A theoretical model was established to analyze the effect of standard device efficiency on the output multi longitudinal mode characteristics of Nd:YVO4 laser, and corresponding experimental research was conducted. In the experiment, longitudinal mode grouping and spectral drift phenomena were explored by rotating the crystal angle. The experimental results indicate that when the laser crystal angle increases from 0?, there are two phenomena: the broadening of the transmission peak linewidth of the etalon and the redshift of the longitudinal mode wavelength. The experimental results are in good agreement with the theoretical model. Finally, when the pump power was 2768 mW and the laser crystal tilt angle was 0.45?, the etalon effect was successfully suppressed, and a mode-locked laser with slope efficiency and optical conversion efficiency of 15.66% and 13.9%, output power of 385 mW, and beam quality of 1.71 was obtained. At this point, by increasing the pump power, it was found that the spatial hole burning effect also produces an effect similar to the etalon effect. The experimental results also indicate that increasing the pump power will exacerbate the phenomenon of spatial hole burning.

    参考文献
    相似文献
    引证文献
引用本文
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2023-08-13
  • 最后修改日期:2023-11-13
  • 录用日期:2023-12-04
  • 在线发布日期:
  • 出版日期: